TOL S.A.

Waterjet cutting for glass

Cutting glass

When cutting glass or other brittle material, it is necessary to pierce at low pressure to avoid breaking the material. Then cutting can be made at high pressure for a better velocity.
Anyway, frequent changes from low pressure to high pressure should be avoided.
So TOLfab solution is to make an initial pass at low pressure where all piercing are done, but cuttind is delayed. Then the machine is switched to high pressure, and the cutting is done.
Once the material has been selected, all these actions are automatically done by TOlfab without the need for the user to deal with these problems.

See too
Angle cutting quality
Waterjet cutting quality
and
Waterjet cutting